C93700 has excellent machining properties, medium strength and good corrosion resistance and will withstand mild acids as found in mine water.

Bearings manufactured from C93700 have excellent wear resistance under conditions of high speed, heavy pressure and vibration, have low friction and can be used where lubrication is less than adequate and there may be minor misalignment. C93700 bearings require a hardened shaft and maximum shaft surface speeds of 4 m/sec can be tolerated.

Applications

Bearings for high speed and heavy pressures, pumps, impellers, corrosion resistant applications, pressure tight castings. 

Hardness*	Brinell Hardness (500 kg load)	60
Tensile Strength**	KSI	35
Yield Strength **	KSI (0.5% Ext. under load)	20
Elongation**	% in 2 inch	20

**Test values are nominal approximations and depend on specimen size and orientation.

Physical Properties

Thermal Conductivity	BTU/ (sq ft-ft-hr-F)	27.1
Specific Heat	BTU/lb/ºF @ 68F	.09
Thermal Expansion	Per °F from 68 F to 392 F	.0000103
Density	lb/cu in @ 68 F	.320
Electrical Conductivity* (Annealed)	% IACS @ 68 F	10
Modulus of Elasticity	KSI	11,000

*Volume basis

Stress relieving temperature	500 F or 260 C
Time at temperature	1 hour per inch of section thickness
Responds to heat treatment	No
Machinability rating (Free Cutting Brass=100)	80
Suitability for being joined by:	Soldering/Good
	Brazing/Good*
	Oxyacetylene Welding/Not Recommended
	Gas Shielded Arc Welding/Not Recommended
	Coated Metal Arc Welding/Not Recommended

*Since brazing is performed at temperatures within the hot-short range, strain must be avoided during the brazing and cooling of this alloy.

The values listed above represent reasonable approximations suitable for general engineering use. Due to commercial variations in composition and to manufacturing limitations, they should not be used for specification purposes. See applicable A.S.T.M. specification references.